DAA Hi-Capacity Powder Hopper

Double-Alpha Academy

Key features

$1.00 Reward points
Save for Later
 Item in Stock | Usually dispatched within 24 hours

Latest reviews

Brunner ***
26 Dec 2023
acheté le 28/11 produit qui fonctionne mais les finitions sont très très mal faites. Je regrette mon achat, je ne recommande pas
Rating: (1 of 5 Stars!)
Karol ***
30 Jun 2020
Ten podajnik jest za krótki i należy go docinać, gdyż się nie mieści.
Rating: (2 of 5 Stars!)
Martin ***
5 May 2019
Nutná úprava (zkrácení a jiné šrouby než originalni)
Rating: (3 of 5 Stars!)


Double the capacity of your Dillon powder hopper with this clear PT extended Hopper. The Hopper measures 36cm long and replaces the 18cm long Dillon Original.

It assembles in the same way, using the two screws in place on the Dillon.

The Dillon cap or Low Powder Sensor will fit and can be used. However, note that you will need to extend the follower rod on the low powder sensor in order to get it to activate correctly at the bottom of this extended hopper.

An acrylic powder baffle is included with the extended hopper.


1050 users, please note: this hopper it too long to fit under the case feeder on your 1050. You will need to shorten it to fit. The tube can be shortened using a saw or serrated knife. About 9cm need to be cut off to fit under the 1050 case feeder.

We Also Recommend

New Products

Important Note
Important Note
$2.00 Reward points